Accepted Payment
Home > Trijicon/Vortex RMR Cuts
Trijicon RMR Cutting Services

Trijicon RMR Slide Cut shown is a raw cut.

Please note that if you do not chose to have your slide Cerakoted this is how you will receive it back. We do recommend that you get it coated.

Custom mill your slide to accept the Trijicon RMR. Works only with the Trijicon RMR. RMR NOT INCLUDED. W also do vortex But you must clarified before work is done.

Our RMR cut is standardized to be milled between the rear sight and the ejection port. We will not alter or change the rear sight location.

RMR cut cannot be done on the GLOCK 30S, 36, 42 or 43.

Please note that standard holsters will not work with RMR's or suppressor sights.

For an additional charge add a steel or aluminum RMR cover plate without the Glockmeister logo engraved into the top.

NOTE: Choosing the aluminum plate can cause the Cerakote color to differ from that of the slide.

After the work has been completed, we can Cerakote your slide for an additional $35 or you can leave your slide unfinished. UNFINISHED SLIDES WILL SHOW BARE UNFINISHED STEEL (NOT BLUED) WHERE THE MILLING OCCURED

The thread pitch for the screws that mount the RMR to the slide is 6-32. This is the factory thread pitch of Trijicon and the ONLY thread pitch we offer.


Before shipping you slide to Headhunters Firearms contact us so we can email and agreement so you can view and print and fill out. This agreement will need to be included with your upper when it is shipped to us. Orders that are received without this signed agreement will be delayed until it is received. This agreement contains warranty, contact information, upper receiver information and mandatory return shipping information. Return shipping is a flat rate of $12 which will be added at checkout. This flat rate is only for the slide; additional products added to your order will incur their own shipping charges.


Cutting Services PricingPrice
Trijicon/Viper RMR cutting with out Cerakote$125.00
RMR cover Plate$25.00